Hydrogenated amorphous silicon carbide
thin films were prepared and studied in a radio‐frequency glow‐discharge system, using a gas mixture of
and one of the following carbon sources: methane
, benzene
, toluene
, σ‐xylene
, trichloroethane
, trichloroethylene
, or carbon tetrachloride
. The effect of doping phosphorus and boron into those
films on chemical etching rate, electrical dc resistivity, breakdown strength, and optical refractive index have been systematically investigated. Their chemical etching properties were examined by immersing in 49%
, buffered
, 180°C
solutions, or in
plasma. It was found that the boron‐doped
film possesses five times slower etching rate than the undoped one, while phosphorus‐doped
film shows about three times slower. Among those
films, the one obtained from a mixture of
and benzene shows the best etch‐resistant property, while the ones obtained from a mixture of
and chlorine containing carbon sources (e.g., trichloroethylene, trichloroethane, or carbon tetrachloride) shows that they are poor in etching resistance (i.e., the etching rate is higher). By measuring dc resistivity, dielectric breakdown strength, and effective refractive index, it was found that boron‐ or phosphorus‐doped
films exhibit much higher dielectric strength and resistivity, but lower etching rate, presumably because of higher density.