In this study, the glass transition temperature Equation or symbol description not availableTg is determined from thermal expansion measurements in a series of glass compositions prepared by bulk fusion of a phosphosilicate matrix to which oxides of boron, germanium, or arsenic are added. On a per‐molar basis, addition of boron was observed to be the most effective in lowering the glass transition temperature of the phosphosilicate matrix, as compared to arsenic or germanium, which is found to be the least effective. For borophosphosilicate glass with concentrations of Equation or symbol description not availableB2O3 less than 13 m/o, values of Equation or symbol description not availableTg are observed to be reduced by increasing the Equation or symbol description not availableP2O5 content. Near Equation or symbol description not available13 m/o B2O3 the temperatures become independent of Equation or symbol description not availableP2O5, while at a still higherEquation or symbol description not availableB2O3 content they are actually raised upon increasing the Equation or symbol description not availableP2O5 concentration. For the germanophosphosilicate glass, no such reversal is noted as values of Equation or symbol description not availableTg decrease slightly with Equation or symbol description not availableP2O5, additions at all Equation or symbol description not availableGeO2 concentrations. Glass compositions with potential VLSI applications can, thus, have the Equation or symbol description not availableP2O5 content reduced to the minimum value required to provide gettering without significantly affecting the glass transition or associated viscous flow parameters. From a comparison of the measured values of Equation or symbol description not availableTg in bulk glasses with reported values of the flow temperature Equation or symbol description not availableTf for films with corresponding compositions, a correlation factor relating those two parameters is established. Thus, the relatively simple thermal expansion technique can now be used to survey for glass compositions with promising flow characteristics without the rigorous and time consuming effort of conducting the more difficult bulk viscosity experiments or developing deposition processes for films with possibly unsuitable viscous characteristics.