Hydrogenated amorphous silicon carbide Equation or symbol description not available(a‐SiC:H) thin films were prepared and studied in a radio‐frequency glow‐discharge system, using a gas mixture of Equation or symbol description not availableSiH4 and one of the following carbon sources: methane Equation or symbol description not available(CH4), benzene Equation or symbol description not available(C6H6), toluene Equation or symbol description not available(C7H8), σ‐xylene Equation or symbol description not available(C8H10), trichloroethane Equation or symbol description not available(C2H3Cl3), trichloroethylene Equation or symbol description not available(C2HCl3), or carbon tetrachloride Equation or symbol description not available(CCl4). The effect of doping phosphorus and boron into those Equation or symbol description not availablea‐SiC:H films on chemical etching rate, electrical dc resistivity, breakdown strength, and optical refractive index have been systematically investigated. Their chemical etching properties were examined by immersing in 49% Equation or symbol description not availableHF, buffered Equation or symbol description not availableHF, 180°C Equation or symbol description not availableH3PO4 solutions, or in Equation or symbol description not availableCF4+O2 plasma. It was found that the boron‐doped Equation or symbol description not availablea‐SiC:H film possesses five times slower etching rate than the undoped one, while phosphorus‐dopedEquation or symbol description not availablea‐SiC:H film shows about three times slower. Among those Equation or symbol description not availablea‐SiC:H films, the one obtained from a mixture of Equation or symbol description not availableSiH4 and benzene shows the best etch‐resistant property, while the ones obtained from a mixture of Equation or symbol description not availableSiH4 and chlorine containing carbon sources (e.g., trichloroethylene, trichloroethane, or carbon tetrachloride) shows that they are poor in etching resistance (i.e., the etching rate is higher). By measuring dc resistivity, dielectric breakdown strength, and effective refractive index, it was found that boron‐ or phosphorus‐doped Equation or symbol description not availablea‐SiC:H films exhibit much higher dielectric strength and resistivity, but lower etching rate, presumably because of higher density.