Batteries and Energy Storage
A19
Guannan He, Yixiao Li, Jie Li and Yong Yang
A22
Yang Dai, Yixiao Zhang, Lei Gao, Guofeng Xu and Jingying Xie
A sodium ion based organic radical battery has been developed using a polynorbornene derivative radical polymer as the cathode active material. The electrochemical performances of the battery are preliminarily investigated, showing the cyclability of the battery. The battery delivers a discharge capacity of
at the 1st cycle and a capacity retention of
at the 50th cycle.
A25
Hongrae Jeon, Beomgyun Jeong, Jae Kwang Lee, Ho Sung Kim, Si-Hyun Lee and Jaeyoung Lee
Fuel Cells and Energy Conversion
B11
Da Qin, Dongmei Li, Zhexun Yu, Yanhong Luo and Qingbo Meng
B14
Zhihong Wang, Zhe Lü, Bo Wei, Xiqiang Huang, Kongfa Chen, Mingliang Liu, Weiping Pan and Wenhui Su
B17
Jong Hoon Joo and Gyeong Man Choi
B21
Yue-Ping Xiong, Haruo Kishimoto, Katsuhiko Yamaji, Masashi Yoshinaga, Teruhisa Horita, Manuel E. Brito and Harumi Yokokawa
The electronic conductivity of pure ceria was successfully measured by a dc polarization technique based on the Hebb–Wagner ion blocking method at
. The electronic conductivity increased with increasing temperature at given
values. It also increased with decreasing
following slope values of −1/6 to −1/4. At 873–1073 K, no
dependent region was observed at higher
more than
,
, and
at 1073, 973, and 873 K, respectively. Activation energies calculated from the Arrhenius plots for those different regions were 2.2, 2.9, and 1.9 eV for
dependences of −1/6, −1/4, and 0 regions, respectively.
B25
P. Boillat, G. Frei, E. H. Lehmann, G. G. Scherer and A. Wokaun
Improvements in the spatial resolution of neutron imaging were specifically developed for application in fuel cell imaging, where the resolution requirement in different directions may vary by 1 order of magnitude, thus making anisotropic setups attractive. A maximal spatial resolution of
could be reached. For the transient studies, the combination of a high resolution of
with exposure times of 10 s proved to resolve the water evolution, both temporally and spatially.
B28
Yoon Ho Cho, Sang-Bu Ha, Dae Soo Jung, Yun Chan Kang and Jong-Heun Lee
Corrosion, Passivation, and Anodic Films
C1
P. Jakupi, J. J. Noël and D. W. Shoesmith
Alloy 22 electrodes crevice corroded under constant current conditions in 5 M NaCl at
accumulated damage predominantly in the form of intergranular corrosion. Electron backscatter diffraction was used to determine the relationship between the location of damage and the crystallographic features of the grains and grain boundaries. The alloy possessed an exceptionally high number of “special”
grain boundaries, and an intergranular attack was observed on random grain boundaries not exhibiting this special grain boundary character. The high percentage of special boundaries offers one reason for the excellent crevice corrosion resistance of this alloy.
Electrochemical/Chemical Deposition and Etching
D11
Tim S. Olson, Rosalba A. Rincón, Dmitri A. Brevnov and Plamen Atanassov
D15
Ning Liu, Lidong Wang, Yaoming Wu and Limin Wang
The electrodeposition of magnesium was investigated by some metal salt additives in dimethylformamide solutions containing
at room temperature. Voltammetric measurements and elemental analyses of electrodepositions revealed that Mg–Al and Mg–Fe alloys were obtained. The foreign metals were electrodeposited and formed many nuclei to allow the growth of Mg.
Dielectric Science and Materials
G25
Hong-Liang Lu, Shi-Jin Ding and David Wei Zhang
MgO thin films have been grown on Si(100) by atomic layer deposition using bis(cyclopentadienyl)magnesium and water as precursors. The effect of rapid thermal annealing (RTA) on thermal stability and interfacial properties of MgO films is investigated by X-ray photoelectron spectroscopy (XPS). XPS results indicate that the as-deposited MgO film is quite reactive to the atmospheric moisture and carbon dioxide and has a sharp interface with the substrate. The spectra of samples annealed at
show that the Mg–OH groups have been turned into MgO. RTA also induces the formation of magnesium silicate, whose content increases with increasing annealing temperature.
G29
Yi Wei Chen, Maozi Liu, Tetsuya Kaneko and Paul C. McIntyre
Semiconductor Devices, Materials, and Processing
H49
Chih-Wei Hu, Ting-Chang Chang, Chun-Hao Tu, Yu-Hao Huang, Chao-Cheng Lin, Min-Chen Chen, Fon-Shan Huang, Simon M. Sze and Tseung-Yuen Tseng
H52
Anand Meled, Yasa Sampurno, Yun Zhuang and Ara Philipossian
In this study, the extent of the pad wear rate during the shallow trench isolation chemical mechanical planarization process was investigated for several combinations of the type of abrasive particles (i.e., colloidal and fumed silica), abrasive content, and abrasive concentration. Results showed a relation between pad wear rate and abrasive concentration for both fumed and colloidal slurries. Results indicated that the pad wear rate using the colloidal silica slurry was higher by approximately 42 and 6% at 3 and 25 wt % silica, respectively. Under the same abrasive content, pad wear rate for fumed slurry was 23% higher compared to colloidal slurry.
H55
Zewen Zuo, Wentian Guan, Yu Xin, Jin Lu, Junzhuan Wang, Lin Pu, Yi Shi and Youdou Zheng
Microcrystalline silicon films without an amorphous incubation layer were deposited onto glass substrates at a high rate and a low temperature by a jet-type inductively coupled plasma chemical vapor deposition (jet-ICPCVD) technique. It was observed that the amorphous incubation layer present at the beginning of the deposition gradually crystallized during the growth process, and an almost completely crystallized layer was obtained. The analysis indicates that high density plasma, spatial plasma potential, and high pressure are of substantive benefit to the generation of abundant energetic hydrogen atoms, which diffuse into the incubation layer and control the crystallization through a hydrogen-mediated chemical reaction.
H58
Ching-Sung Lee and Bo-Yi Chou
H61
M. M. R. Howlader, T. Suga, F. Zhang, T. H. Lee and M. J. Kim
The interfacial behavior of the bonded p-GaP/n-GaAs wafers, with activated surfaces, that use an Ar fast atom beam was investigated. The bonding strength of the interface was 9.8 MPa at room temperature, and the GaP was fractured and remained on the GaAs following the tensile test. Two amorphous layers with identical thicknesses of 3.5 nm were found across the interface without annealing. When annealing was executed, the electrical current–voltage characteristics improved and the amorphous layers diminished across the interface. The amorphous layers adjacent to the GaP across the interface are attributed to the Ga-rich layer because of the depletion of P.
H66
Ki-Won Kim, Dong-Seok Kim, Jung-Hee Lee, Jae-Hoon Lee and Cheol-Koo Hahn
H70
N. Ioannou, D. Skarlatos, N. Z. Vouroutzis, S. N. Georga, C. A. Krontiras and C. Tsamis
H73
Po-Chin Chan, Ingram Yin-Ku Chang, Pi-Chun Juan and Joseph Ya-min Lee
H76
G. Dingemans, M. C. M. van de Sanden and W. M. M. Kessels
H80
Musarrat Hasan, Sun Jin Yun, Jae Bon Koo, Sang Hee Ko Park, Yong Hae Kim, Seung Youl Kang, Jonghyun Rho, Jee Hoon Kim, Houk Jang, Jong-Hyun Ahn et al
H83
Chen-Han Lin and Yue Kuo
Metal-oxide-semiconductor memory capacitors composed of dual-layer nanocrystalline ZnO embedded zirconium-doped hafnium oxide high-
film were fabricated, characterized, and compared with those with the single-layer nanocrystalline ZnO embedded sample. Distinct layers of discretely dispersed nanocrystalline dots embedded in the amorphous high-
matrix were observed. The nanocrystalline ZnO dots trap many electrons. The dual-layer sample not only drastically increases the charge storage density but also improves the charge trapping speed due to the coulomb blockade effect. This is a potentially important gate dielectric structure for high density, high speed nonvolatile memories.
H87
X. B. Yan, K. Li, J. Yin, Y. D. Xia, H. X. Guo, L. Chen and Z. G. Liu
Reproducible and reliable bipolar resistive switching was obtained from
memory cells. The current–voltage characteristic of the Ag/STO/Pt cells with a positive voltage applied to the Pt electrode and the results of X-ray photoelectron spectroscopy imply that the electrochemical reaction and the diffusion of
ions play a critical role in the resistive switching effect. The temperature dependence of the on-state resistance, combined with the time dependence of the on- and off-state resistances under a constant voltage, provides further evidence that the resistive switching mechanism should be ascribed to the formation and dissolution of the metallic Ag nanofilaments.
H90
Chia-Feng Lin, Chun-Min Lin, Kuei-Ting Chen, Ming-Shiou Lin and Jing-Jie Dai
Green InGaN-based light-emitting diodes (LEDs) with roughened microhole-array (MHA) structures were fabricated through a dry etching process and a photoelectrochemical (PEC) process. The PEC process consisted of a bandgap-selective lateral etching process at the InGaN active layer, an N-face bottom-up crystallographic etching process at the bottom p-type GaN:Mg layer, and a PEC oxidation process at the n-type GaN:Si surface. The light output power of the MHA-LED and the photoelectrochemically treated microhole-array light-emitting diode (PMHA-LED) had 7 and 65% enhancement, respectively, compared to a conventional LED at a 20 mA operation current.
Sensors and Displays: Principles, Materials, and Processing
J15
Bitao Liu, Yuhua Wang, Zhaofeng Wang, Jun Zhou and Xiaolan Gao
J18
Xue Yu, Yuhua Wang and Jidi Liu
J21
Hong He, Renli Fu, Xinran Zhao, Xiufeng Song, Zhengwei Pan, Shaodong Zhang, Zhonghua Deng and Yongge Cao
Nanostructured Materials, Carbon Nanotubes, and Fullerenes
K19
Il Seo, Do-Joong Lee, Quanli Hu, Chang-Woo Kwon, Kipil Lim, Seung-Hyun Lee, Hyun-Mi Kim, Yong-Sang Kim, Hyun Ho Lee, Du Yeol Ryu et al
K22
Rosalinda Inguanta, Patrizia Livreri, Salvatore Piazza and Carmelo Sunseri
In this work, we report some preliminary results concerning the fabrication of quaternary copper, indium, gallium, and selenium (CIGS) nanowires that were grown inside the channels of an anodic alumina membrane by one-step potentiostatic deposition at different applied potentials and room temperature. A tunable nanowire composition was achieved through a manipulation of the applied potential and electrolyte composition. X-ray diffraction analysis showed that nanowires, whose chemical composition was determined by energy-dispersive spectroscopy analysis, were amorphous. A composition of
, very close to the stoichiometric value, was obtained. These nanostructures were also characterized by photoelectrochemical measurements: They showed a cathodic photocurrent and an optical gap of 1.55 eV.
K26
A. Podhorodecki, J. Misiewicz, F. Gourbilleau, J. Cardin and C. Dufour
In this work, direct experimental evidence of the excitation energy transfer from silicon quantum dots (Si-QDs) to Nd ions has been given based on photoluminescence (PL) and PL excitation measurements in a wide spectral range. The indirect excitation of Nd ions by transfer from excited Si-QDs is possible and even more efficient at higher energy levels
than the indirect excitation reported up to now at lower energy
levels.
Miscellaneous
S1
Kyung Min Kim, Sang Young Lee, Gyu Jin Choi, Jeong Hwan Han and Cheol Seong Hwang