Batteries and Energy Storage
A11
Yan Qin, Zonghai Chen, Jun Liu and Khalil Amine
A15
Hyun Sik Kim, Soon Hyung Kang, Young Hoon Chung and Yung-Eun Sung
A nanophase tin (Sn) layer was coated on self-ordered
nanotube (TONT) arrays of 400 nm length and 120 nm diameter by using a radio-frequency magnetron sputtering method followed by heat-treatment at low temperature. The morphological and structural characterization of the Sn-coated TONT (Sn/TONT) revealed the presence of a well-dispersed, nanophase Sn layer along the inner and outer walls of the TONTs. When used as the anode material in lithium-ion batteries, the Sn/TONT electrode exhibited high reversible capacity and coulombic efficiency in the first cycle, excellent capacity retention, and a rate capability higher than that of the uncoated TONT electrode.
Fuel Cells and Energy Conversion
B5
Sivagaminathan Balasubramanian, Charles E. Holland and John W. Weidner
A twin-cell electrochemical filter is demonstrated to reduce the CO concentration in reformate hydrogen. In this design, the potential and gas flow are switched between the two filter cells so that alternative CO adsorption and oxidation occur in each cell while providing a continuous flow of
to a fuel cell. The effects of filter switching time and applied potential on the CO concentration of gas exiting the filter are presented here for a CO concentration of 1000 ppm in nitrogen flowing at
. The parasitic loss of hydrogen from a corresponding reformate stream was estimated to be 1.5%.
B8
Yongcheng Jin, Keisuke Fujiwara and Takashi Hibino
Electrochemical/Chemical Deposition and Etching
D1
Ji Hye Kang, Hyung Gu Kim, Jae Hyoung Ryu, Hyun Kyu Kim, Hee Yun Kim, Jin Joo, Mi So Lee, Young Jae Park, Periyayya Uthirakumar and Chang-Hee Hong
The light output power of light emitting diodes (LEDs) has been enhanced using nanoroughed hemispherical indium tin oxide (ITO) transparent ohmic contacts. The hemispherical shape is easily achieved by evaporating ITO film on an ITO nanosphere, and the aspect ratio of an individual hemispherical ITO is determined by the size of the ITO nanosphere. The diameter of the ITO nanospheres can be easily controlled by controlling the thickness of the ITO films. The light extraction efficiency of InGaN/GaN LEDs is significantly improved due to light incident at an angle of approximately 90° at the hemispherical nanoroughed prominence–air interface. Also, a high surface area of ITO prominences increases the light extraction efficiency. Thus, the light output power of the nanoroughed hemispherical LEDs is increased by 30% compared to conventional LEDs at an injection current of 20 mA.
D4
Mary Donnabelle L. Balela, Shunsuke Yagi and Eiichiro Matsubara
Metallic Co nanoparticles of 24–110 nm diameters are prepared by electroless deposition (chemical reduction) in an aqueous solution at room temperature. The reduction process is monitored by an in situ measurement of a mixed potential. The mixed potential, which is above the redox potential of a Co(II)/Co redox pair, drops by the addition of the nucleating agent
and also decreases with an increase in the
concentration. Smaller Co nanoparticles are formed. In the smaller particle size, the fraction of the face-centered cubic Co phase increases, and the hexagonal close-packed Co phase decreases.
D7
Ho-Cheng Tsai, Yu-Chen Chang and Pu-Wei Wu
4-Amino-2,1,3-benzothiadiazole and 6-aminobenzo-thiazole were studied as potential levelers for Cu plating in submicrometer trenches. We conducted galvanostatic measurements on rotating disk electrodes at various concentrations and recorded their respective voltages at 200 and
. A profile of voltage difference between them at various concentrations revealed a volcano curve in which superfilling was expected to occur for 4-amino-2,1,3-benzothiadiazole but not for 6-aminobenzo-thiazole. Direct scanning electron microscopy observations on the plated Cu confirmed predictions from the volcano curves. A diffusion–adsorption mechanism was proposed for these two compounds to explain their leveling abilities on Cu superfilling.
Electrochemical Synthesis and Engineering
E1
Shunsuke Yagi, Makoto Kawamori and Eiichiro Matsubara
The synthesis process of cobalt nanoparticles via electroless deposition in ethylene glycol (EG) was investigated by electrochemical quartz crystal microbalance (QCM). The oxidation–reduction potential of the Co(II)/Co redox pair in EG could not be thermodynamically calculated because of insufficient thermodynamic data in organic solvents. We experimentally determined the oxidation–reduction potential of the Co(II)/Co redox pair in EG by cyclic voltammetry combined with QCM. The reaction start and end points were also determined by QCM. The effect of the nucleating agent
on the cobalt deposition behavior and particle size distribution was examined.
Physical and Analytical Electrochemistry
F1
Daniel A. Scherson and Yuriy V. Tolmachev
Impurity effects associated with an increase in the rate of mass transport induced by a decrease in the size of electrodes have been examined with emphasis on species capable of undergoing irreversible adsorption. Calculations show that for hemispherical ultramicroelectrodes
in radius, the flux of a solution-phase contaminant, such as a small organic molecule, present at ppb levels, is large enough to reach saturation coverage over times on the order of seconds. In the case of dioxygen reduction on Pt in aqueous electrolytes, such adsorbed species are believed to be responsible for marked changes in the mechanism, promoting a two-electron over a four-electrode reduction pathway. Such aspects must be considered in the analysis of results obtained with Pt ultramicroelectrodes, either as single particles or in dilute arrays.
Dielectric Science and Materials
G9
Jiagang Wu, Xiaojie Lou, Yang Wang and John Wang
G13
Seok-Jun Won, Sungin Suh, Sang Woon Lee, Gyu-Jin Choi, Cheol Seong Hwang and Hyeong Joon Kim
G17
Jung Wook Lim, Seong Hyun Lee, Jun Kwan Kim and Sun Jin Yun
The antireflection (AR) properties of
and
films were investigated for the application of an AR coating of thin-film solar cells. Their optical transmittance was measured to exceed 85% over the entire visible and near-IR spectrum. The AR layers of these films coated on transparent conductive oxide (TCO)/Si exhibited 18% lower reflection than an uncoated TCO/Si at wavelengths from 400 to 900 nm. Furthermore, the thicknesses of the AR layers and TCO were demonstrated to influence the amount and shape of reflectivity in the reflection curves for the AR/TCO/Si structure.
G21
L. Wu, H. Y. Yu, K. L. Pey, J. S. Pan, M. Tuominen, Eva Tois, D. Y. Lee, K. Y. Hsu, K. T. Huang, H. J. Tao et al
Semiconductor Devices, Materials, and Processing
H27
C. S. Tan and G. Y. Chong
H30
Jeong Ho Ryu, Hyung Sik Won, Youn-Gon Park, Sang Hyun Kim, Won Young Song, Hideo Suzuki, Chang-Bun Yoon, Do Hwan Kim, Woo Jung Park and Chulsoo Yoon
H33
Se-Yeon Jung, Kyeong Heon Kim, Sang-Yong Jeong, Joon-Woo Jeon, Jihyung Moon, Sang Youl Lee, June-O Song, Young Tae Byun and Tae-Yeon Seong
Single-wall carbon nanotubes (SWCNTs) have been combined with indium tin oxide (ITO) to improve the output power of GaN-based light emitting diodes (LEDs). LEDs fabricated with the SWCNT/ITO contacts give a forward voltage of 3.61 V at 350 mA, which is slightly higher than that of LEDs with ITO-only contacts. The SWCNT/ITO and ITO-only contacts produce transmittance values of 91.5 and 94.4% at 460 nm, respectively. However, LEDs with SWCNTs show a higher output power by 60% at 20 mA compared to those without SWCNTs. Photoemission microscope analyses show that the well-dispersed SWCNT bundle efficiently serves as a current spreader.
H36
Shimeng Yu, Bin Gao, Haibo Dai, Bing Sun, Lifeng Liu, Xiaoyan Liu, Ruqi Han, Jinfeng Kang and Bin Yu
H39
Yu Yang, Riet Labie, Olivier Richard, Hugo Bender, Chao Zhao, Bert Verlinden and Ingrid De Wolf
H42
Hyung Gu Kim, Hee Yun Kim, Hyun Kyu Kim, Jae Hyoung Ryu, Ji Hye Kang, Nam Han, Periyayya Uthirakumar and Chang-Hee Hong
We report characteristics of the InGaN/GaN light emitting diodes (LEDs) grown by selective metallorganic chemical vapor deposition with embedded air prisms (EAPs) via a wet etching process. At first, aqueous KOH solution, an etchant, removed the
mask pattern to facilitate a subsequent etching through N-face GaN to achieve crystallographically defined prism shapes. Well-aligned arrays of air prisms are formed and distributed throughout the entire device. The EAP–LED output power was increased 2.1 times compared with the conventional LED. The higher light extraction is attributed to the improvement in the scattering of photons at the EAP interface due to the large index difference between GaN and air prisms.
H45
J. D. Hwang, Y. H. Chen and P. S. Chen
Sensors and Displays: Principles, Materials, and Processing
J11
Suyin Zhang, Yanlin Huang, Weifang Kai, Liang Shi and Hyo Jin Seo
Nanostructured Materials, Carbon Nanotubes, and Fullerenes
K5
Matthew L. Gross and Michael A. Hickner
K8
Dongbok Lee, Sung-Soo Yim, Ho-Ki Lyeo, Min-Ho Kwon, Dongmin Kang, Hyun-Goo Jun, Sung-Wook Nam and Ki-Bum Kim
K12
Bo Hyun Kong, Mi Kyung Choi, Hyung Koun Cho, Jae Hyun Kim, Sungho Baek and Jung-Ho Lee
Al-doped ZnO (AZO) thin films were grown by atomic layer deposition (ALD) for use as transparent conductive oxides on high aspect ratio Si microrod arrays. The ALD-deposited AZO films showed high optical transmittance and electrical conductivity despite their polycrystalline structures and resulted in a superior conformal coating on the surface and side regions of the Si microrods. The films also exhibited an electrical performance identical to that of the AZO film on a flat Si substrate. These results revealed that ALD-deposited AZO films are promising candidates for electrodes in the next-generation optoelectronic devices based on low dimensional structures, which require conformal coating.
K15
K. Rumpf, P. Granitzer, M. Albu and P. Poelt
Deposition of magnetic nanostructures into porous silicon (PS) matrices performed electrochemically or by infiltration merges the electronic properties of a semiconductor and the magnetic ones of the incorporated material. The PS templates used exhibit unconnected mesopores with a high aspect ratio of about 1000. Magnetization measurements of such hybrid materials show two characteristic field regions, one at magnetic fields below the saturation magnetization
of the deposited metals due to the spin magnetism and another one at higher fields above
, which is assigned to an intensively investigated magnetic contribution likely caused by a spin–orbit interaction.
Interdisciplinary Topics
P1
Huanfeng Zhu, Barry Miller and Daniel Scherson
The behavior of semiconductor-based, light-activated microelectrodes in redox electrolytes has been examined theoretically using commercial software to self-consistently solve the transport equations for solid-state and solution-phase species and the electrostatic potential within the semiconductor phase, subject to the appropriate boundary conditions under steady state. The light-limited currents for such spatially localized microelectrodes, observed for a high voltage bias,
, under normal irradiation and a strict axisymmetric geometry, were proportional to the photon flux intensity. The results of these simulations afforded strong evidence that under high
, holes generated by the light on an n-type semiconductor escape beyond the edge of the illuminated disk, leading to a net increase in the predicted current and thus in the effective area of the light-activated microelectrode.