In MgB2
the correlation of microstructure with superconducting properties, in
particular the critical current density, requires powerful analytical
tools. Critical current densities and electrical resistivities of different
MgB2
superconductors differ by orders of magnitudes and the current
limiting mechanisms have not been fully understood. Granularity of
MgB2 is one
significant reason for reduced critical current densities and is introduced intrinsically by the anisotropy
of Bc2
but also extrinsically by the microstructure of the material.
Bc2
enhancement by doping is another important challenge for chemical
analysis and, at present, doping levels are not well controlled on the
sub-µm
scale.
In this paper the quantitative electron microscopy and spectroscopy methods essential for the microstructural
analysis of MgB2
are described. By quantitative electron microscopy and spectroscopy we mean
a combined SEM and TEM analysis that covers various length scales from
µm
to nm. Contamination-free sample preparation, chemical mapping including B,
and advanced chemical quantification using x-ray microanalysis were essential
elements of the applied methodology. The methodology was applied to in situ and
ex situ MgB2
wires and tapes with and without SiC additives. Quantitative B analysis by EDX
spectroscopy was applied quantitatively in the SEM and TEM, which is a major
achievement.
Although MgB2
is a binary system, the thermodynamics of phase formation is complex, and the
complexity is dramatically increased if additives like SiC are used. The small,
sub-µm
grain sizes of the matrix and secondary phases require TEM methods. However, granularity on the
µm
scale was also identified and underlines the importance of the combined SEM
and TEM studies. Significant differences in the microstructure were observed for
in situ and ex situ samples. This holds particularly if SiC was added and yielded
Mg2Si for in situ samples
annealed at 600–650 °C
and Mg–Si–O phases for ex situ samples annealed between
900–1050 °C. Only with such a systematic approach combining a large number of microscopy and
spectroscopy methods, could a microstructure critical current density model be established
that will be presented in another paper. Four microstructural parameters were identified
as relevant for the critical current density of wires and tapes and these were:
(1) MgB2
grain size, (2) colony size (a colony is a dense arrangement of
MgB2
grains), (3) oxygen content and (4) volume fraction of B-rich secondary phases.
MgB2
grain size can only be determined by TEM, while colony size, oxygen content and volume
fraction of B-rich secondary phases were determined by SEM methods. The formation of
oxides was also studied in detail by TEM methods. The importance of electron
microscopy methods in the understanding of the thermodynamics of phase formation in
MgB2
as well as in improving the synthesis technology and the superconducting properties of
MgB2
wires and tapes is described.