The effects of thermal cycling on residual stresses in both silicon nitride Equation or symbol description not available(SiNx) deposited on silicon wafers and benzocyclobutene (BCB) coated silicon wafers are discussed. The Equation or symbol description not availableSiNx is deposited by plasma-enhanced chemical vapor deposition (PECVD). A model for the effect of thermal cycling on residual stresses helps explain the effects of thermal cycling on critical adhesion energy (CAE) between Equation or symbol description not availableSiNx and BCB films in bonded wafer configuration Equation or symbol description not availableSi∕SiNx∕BCB∕SiNx∕Si. The wafers are bonded with BCB using an established baseline process. CAE is measured using four-point bending. In thermal cycling experiments conducted between Equation or symbol description not available25°C and either 350 or Equation or symbol description not available400°C, the CAE at the interface between BCB and Equation or symbol description not availableSiNx decreases. This trend in CAE agrees with our model’s prediction that an increase in residual tensile stress within Equation or symbol description not availableSiNx after thermal cycling leads to the observed decrease in CAE. This result is compared with that obtained for bonded wafer configuration Si/PECVD Equation or symbol description not availableSiO2/BCB/PECVD Equation or symbol description not availableSiO2∕Si, where the decrease in residual compressive stress within Equation or symbol description not availableSiO2 induces an increase in CAE. These opposite trends in CAEs of the structures that include Equation or symbol description not availableSiNx or Equation or symbol description not availableSiO2 layers are caused by condensation reactions in the layers, followed by desorption of water, which makes the films more tensile.