The chemical conversion of Equation or symbol description not availableAg2O films on Ag surfaces to Equation or symbol description not availableAgI in aqueous iodide solutions has been studied electrochemically. Equation or symbol description not availableAg2O films were grown potentiostatically and then exposed to Equation or symbol description not availableI− solutions. The chemical conversion process was followed at open-circuit potential Equation or symbol description not available(EOC) using cathodic stripping voltammetry performed after various exposure periods. The Equation or symbol description not availableEOC showed a sudden drop at the completion of the conversion of Equation or symbol description not availableAg2O to Equation or symbol description not availableAgI, reaching a steady-state value close to the equilibrium potential for Equation or symbol description not availableAgI∕Ag and the iodide solution. This sudden drop in Equation or symbol description not availableEOC allowed easy determination of the total reaction time required for complete conversion of Equation or symbol description not availableAg2O to Equation or symbol description not availableAgI. Distinctly separated current peaks were observed for the cathodic reduction of Equation or symbol description not availableAg2O and Equation or symbol description not availableAgI to Ag, and the charges associated with these peaks provided a measure of the amount of Equation or symbol description not availableAg2O converted. The conversion reaction was 100% efficient. The total reaction times from the Equation or symbol description not availableEOC measurements and the cathodic stripping results were used to determine the reaction order and rate constant required for the development of nuclear reactor safety assessment codes.