A positive lead‐acid battery electrode made by the direct incorporation of Equation or symbol description not availablePbO2 and a binder into the grid was described in the previous paper (1). The performance of “Precharged” Equation or symbol description not availablePbO2 electrodes formulated with Equation or symbol description not availablePbO2 from various sources is reported in this paper. The Equation or symbol description not availablePbO2 samples were first characterized by x‐ray diffraction, wet chemical analysis, differential scanning calorimetry, thermogravimetric analysis, BET surface area, and particle size distribution. Positive plates made from these Equation or symbol description not availablePbO2 samples were constructed using tetrabasic lead sulfate and other materials as binders according to the “Precharged” plate concept previously described (1). Performance of these plates correlates with active material morphology and Equation or symbol description not availablePbO2 particle size rather than any intrinsic Equation or symbol description not availablePbO2 activity. Tetrabasic lead sulfate (TTB) and lead sulfate were shown to be the preferred binding materials for the “Precharged” positive plate. Plates made with about 30% TTB and strengthened for early cycle performance with dynel fiber and Teflon for green strength exhibited superior cycle life performance on a simulated automotive cycle life test relative to conventionally prepared positive electrodes.