Abstract
A process to manufacture the positive plate of the lead‐acid battery that eliminates conventional curing and formation steps via the direct incorporation of
active material into the grid is described. "Precharged" plates made from a mixture of tetrabasic lead sulfate,
, and water were found to be strong and capable of delivering first cycle (i.e., with no formation) cranking rate capacity which was 35% of conventionally produced plates tested in the same format. Full capacity is obtainable within three to five charge‐discharge cycles. At this point, the precharged plates were found to be structurally indistinguishable from conventionally processed plates. To ensure in these initial studies that the
was electrochemically active, the material was obtained from electrochemically formed conventional positive plates. The successful use of chemically prepared
is demonstrated in the following paper. This new process is simple and will allow the manufacture of ready-to-use plates on modern automated expanded metal platemaking equipment.
Access this article
The computer you are using is not registered by an institution with a subscription to this article. Please choose one of the options below.

