Abstract
A sputter-prepared Ru (7 nm)/
(8 nm) stacked layer was investigated as a diffusion barrier layer between Cu and Si for direct-plateable Cu interconnects, and its performance was compared with that of a Ru single layer with the same thickness (15 nm). X-ray diffractometry and sheet resistance measurements showed that the incorporation of
into the Ru single layer system significantly improved the barrier performance against Cu diffusion. The
bilayer barrier stack failed due to Cu diffusion attack after annealing at
for 30 min, while the Ru single layer failed after annealing at
by the formation of Cu silicide
. A high resolution transmission electron microscopy analysis clearly suggested that this was due to the excellent diffusion barrier performance of
film with a nanocrystalline structure embedded in an amorphous matrix.
Access this article
The computer you are using is not registered by an institution with a subscription to this article. Please choose one of the options below.
