Partially Zr-substituted Equation or symbol description not availableBaFe1−yZryO3−δ membranes were developed as a Co-free oxygen permeable membrane. In order to stabilize the cubic perovskite structure, Fe sites in Equation or symbol description not availableBaFeO3−δ were partially substituted with Equation or symbol description not availableZr4+. In the substitution range of Equation or symbol description not availabley=0.01–0.1, the cubic perovskite structure was stabilized even at room temperature. Among the membranes prepared, a Equation or symbol description not availableBaFe0.975Zr0.025O3−δ material Equation or symbol description not available(y=0.025) showed the highest oxygen permeation flux of Equation or symbol description not available1.30cm3 (standard temperature pressure) Equation or symbol description not availablemin−1cm−2 at Equation or symbol description not available930°C under an air/He gradient. The oxygen permeation flux was higher than that of partially Ce-substituted Equation or symbol description not availableBaFe1−yCeyO3−δ membranes reported previously. From the results obtained by chemical and scanning electron microscope analyses, it appears that the oxygen permeability for Equation or symbol description not availableBaFe1−yZryO3−δ membranes was well correlated with the amount of oxygen defects in the lattice as well as the grain size. In addition, the oxygen permeation flux of the Equation or symbol description not availableBaFe0.975Zr0.025O3−δ membrane was significantly increased after decreasing the thickness of the membrane from Equation or symbol description not available2.0to0.4mm. For thin membranes Equation or symbol description not available(0.4–1.0mm), the thickness dependence of the oxygen permeability deviated from the Wagner equation, suggesting that the oxygen permeation of Equation or symbol description not availableBaFe0.975Zr0.025O3−δ is controlled by not only bulk diffusion of oxide ions but also their surface reactions.