The effect of different heat-treatments during the hydrogen-induced exfoliation of a thin InP layer to control surface roughness was investigated. Hydrogen implantation was carried out by implanting InP with Equation or symbol description not available5×1016H2+∕cm2 at Equation or symbol description not available150keV. Exfoliation and transfer of the layer to a GaAs substrate occurred at either 150 or Equation or symbol description not available300°C. Exfoliation at Equation or symbol description not available150°C produced smoother surfaces, Equation or symbol description not available2.8nm, compared to the sample exfoliated at Equation or symbol description not available300°C, Equation or symbol description not available8.5nm. This change in surface morphology exhibits a much larger impact than the effect of implantation energy (i.e., straggle) on the surface morphology. The difference is attributed to the ability to trap hydrogen and form extended defects parallel to the surface at the lower temperature. Additionally, the exfoliation depth of the lower temperature specimen is slightly deeper than the specimen exfoliated at Equation or symbol description not available300°C, indicating that the hydrogen diffuses towards the peak damage region at the higher temperatures.