This work examines the overpotential behavior of two types of single cells with Equation or symbol description not availableNi–Cr (cell I) and Equation or symbol description not availableNi–Al (cell II) anodes while under varying pressures up to Equation or symbol description not available3atm. Inert gas step addition (ISA) and steady-state-polarization methods were employed. These methods revealed that cell I showed a lower anodic and cathodic overpotential ascribed to the gas-phase mass-transfer process compared to cell II. The results of the Hg porosimetry show that the Equation or symbol description not availableNi–Al anode has a more uniform pore structure with a smaller amount of small-size pores compared to the Equation or symbol description not availableNi–Cr anode, which implies that the anode of cell II Equation or symbol description not available(Ni–Al) has a lower electrolyte content, resulting in a larger overpotential due to the increased diffusion resistance inside the pores. Both cells showed enlarged gas-phase-resistance induced overpotential at Equation or symbol description not available3atm of pressure. Theoretically, reduced gas-phase diffusivity and flow velocity under pressurized conditions increase gas-phase mass-transfer resistance and its overpotential. However, pressurization reduces the overpotential of the liquid-phase mass-transfer resistance, which results in a total overvoltage decrease under pressurization.