The effects of lower equivalent weight (EW) perfluorosulfonic acid (PFSA) ionomers and Equation or symbol description not availablePt-Co∕C catalyst on the cathode performance of proton exchange membrane fuel cells (PEMFCs) were investigated at two atmospheric pressure operating conditions: low temperature/high relative humidity (RH), Equation or symbol description not available80°C∕100% RH, and high temperature/low RH, Equation or symbol description not available120°C∕35% RH. Cell voltage at a current density of Equation or symbol description not available400mA∕cm2 was used for the performance comparison. The optimized content in the electrode changed with the ionomer EW, from 32% for 1100 EW Nafion, 28% for 920 EW Nafion to 25% for a developmental PFSA 800 EW ionomer. Compared to 1100 EW Nafion, 800 EW ionomer significantly improved the cell performance by 39 mV at Equation or symbol description not available120°C∕35% RH; however, at Equation or symbol description not available80°C∕100% RH, its effect was not apparent. The introduction of Equation or symbol description not availablePt-Co∕C catalyst into the cathode increased the cell performance by Equation or symbol description not available43mV at Equation or symbol description not available80°C∕100% RH, which was much higher than a performance improvement at Equation or symbol description not available120°C∕35% RH. Compared to electrodes made of Equation or symbol description not availablePt∕C and Nafion 1100 EW, the combination of 800 EW Ionomer and Equation or symbol description not availablePt-Co∕C catalyst resulted in a Equation or symbol description not available55mV cell voltage increase at Equation or symbol description not available80°C∕100% RH and a Equation or symbol description not available48mV cell voltage increase at Equation or symbol description not available120°C∕35% RH.