Concurrent linear sweep voltammetry, coulometry, and electrochemical quartz crystal microgravimetry (EQCM) were used, we believe for the first time, to study anodic corrosion layers at lead. These corrosion layers were first generated on the lead surface at 0.8 V (vs. Equation or symbol description not availableAg/AgCl/satd. Equation or symbol description not availableKCl reference) either in 4.5M Equation or symbol description not availableH2SO4 or 0.1M Equation or symbol description not availableNa2SO4. A subsequent cathodic voltammetry scan revealed waves due to the reduction of the corrosion layer. Coulometry and EQCM analyses were then performed within the potential window corresponding to each cathodic wave. From these charge and mass measurements respectively, an Equation or symbol description not availablen/ΔM parameter (Equation or symbol description not availablen=electron stoichiometry, Equation or symbol description not availableΔM=molar mass difference between solid products and reactants) could be extracted and compared with the value computed for a model reaction candidate. We thus show that basic lead sulfates can be detected in the presence of both Equation or symbol description not availablePbO and Equation or symbol description not availablePbSO4. Thus Equation or symbol description not availablePbO·PbSO4 is shown to be a corrosion product in 4.5M Equation or symbol description not availableH2SO4 while Equation or symbol description not available3 PbO·PbSO4·H2O is generated at the lead surface in 0.1M Equation or symbol description not availableNa2SO4.