85 Ag‐15 Cu flex leads, used as current‐carrying conductors in inertial instruments, corrode in a BTFE (bromotrifluoroethylene) fluid environment The corrosion scale has a nodular appearance similar to that of the Ag‐rich particles which are present in the flex lead matrix. The Ag‐rich phase is the predominant phase in the material and exists as discrete particles surrounded by the Cu‐rich phase located at what appears as a quasi‐continuous network of grain boundaries. Corrosion proceeds along the Cu‐rich phase resulting in separation of the Ag‐rich metallic particles from the matrix and incorporation into the corrosion debris. After buildup of a certain thickness, the corrosion layer detaches from the flex lead (contaminating the fluid) and exposes fresh metal surface for more attack. When the chemical etching behavior of a good lead (one that showed negligible corrosion) was compared to that of a poor lead (where substantial corrosion effects were observed), the good lead was found to etch more slowly, by at least a factor of six. The differences in etching behavior have been attributed mainly to differences in prior thermal history, and partly to possible local variations in overall composition. The observed corrosion has been explained by mechanisms involving chemical reaction between the metallic phases and the fluid, and those involving the formation of an electrochemical corrosion cell.