The cause of a process‐induced leakage current in low noise Equation or symbol description not availableGaAs MESFET's has been traced to conduction along the semi‐insulating buffer surface surrounding the mesas that contain the active elements of the device. The ion milling process, which we used to define the mesas, is responsible for inducing large, variable increases in surface leakage. For a fixed voltage between the gate and source pads of 1V the induced leakage current ranged from 5 nA to 10 μA at 23°C. We compared the effects of several commonly used etches for cleaning Equation or symbol description not availableGaAs. A buffered peroxide solution did not reduce the induced leakage current. By contrast, a concentrated aqueous Equation or symbol description not availableNH4OH solution reproducibly reduced the induced leakage current to below 1 nA. Auger analysis revealed a correlation between high surface leakage and the presence of a surface Ga oxide layer. We were unable to definitively identify the cause of the leakage, but suggest two possible mechanisms that are consistent with our data: (i) band bending due to charges in the surface oxide, or surface state effects, and (ii) conduction through a thin layer of elemental As located between the surface oxide and the Equation or symbol description not availableGaAs.