Abstract
Conventional photoresists have been modified by the incorporation of a phosphorus‐containing compound, i.e., phosphonitrilic chloride trimer
. The modification was achieved by simply dissolving
(PNCT) in conventional photoresists. The phosphorus concentration varied from 5 weight percent (w/o) to 12 w/o in the modified photoresist films. These films formed a barrier layer when exposed to oxygen plasmas. After the layer was formed, no measurable resist etch rate could be detected. The resolution and mechanical properties of the modified resist films were essentially unchanged, although an increase by a factor of 1.5 in the exposure threshold was observed. Features of less than 1 μm lines and spaces were anisotropically etched in polyimide masked by this photoresist. Furthermore, metal lift‐off structures have been obtained using a bilayer process employing the modified resist.
Access this article
The computer you are using is not registered by an institution with a subscription to this article. Please choose one of the options below.
