Abstract
The effect of part per billion (ppb) levels of
on the atmospheric corrosion on Al (99.999%) was investigated in the laboratory at 22°C. Exposure time was 20 and 672 h. The effect of
concentration (46-1300 ppb), relative humidity (70-99% RH), and the amount of NaCl applied prior to exposure
was studied. In addition, the effect of
and
on the
deposition rate was addressed. The samples were investigated by gravimetry, grazing incidence X-ray powder diffraction, ion chromatography, optical microscopy, and environmental scanning electron microscopy equipped with energy-dispersive X-ray fluorescence.
accelerates the atmospheric corrosion of Al, forming corrosion product “islands” containing aluminum hydroxy sulfate. Combining NaCl and
has a synergistic effect on the average corrosion rate. In contrast, the chloride-induced pitting of aluminum is significantly reduced by
. The corrosivity of
is attributed to the acidification of the surface electrolyte that destabilizes the alumina passive film. The suppression of pitting corrosion by
is attributed to the formation of aluminum hydroxy sulfates that are less soluble than the corresponding chlorides and slows down pit propagation. At relative humidities above 70% RH, there is a measurable steady-state deposition of
that corresponds to the rate of formation of sulfate. The
deposition rate is not limited by the oxidation of (IV)-valent sulfur on the surface.
deposition is enhanced by sodium chloride because the corrosion reactions in the NaCl(aq) electrolyte result in high pH in the cathodic regions and the formation of aluminum hydroxide. Ozone in the ppb range has only transient effects on the
deposition rate, whereas ppb levels of
had no effect at all.
Access this article
The computer you are using is not registered by an institution with a subscription to this article. Please choose one of the options below.
