Abstract
Aluminum‐Germanium (Al‐Ge) sputtering at elevated substrate temperature is proposed for quarter‐micron contact hole filling. Filling and electrical characteristics of contact holes filled with Al‐5%Ge were investigated. Al‐5%Ge flowed and its grains grew to approximately 5 μm diam during sputtering in the temperature range of 200 to 300°C. Contact holes with a 0.25 μm diam and aspect ratio of 4 were successfully filled with Al‐5%Ge at 300°C, using a poly‐Si underlayer. The poly‐Si underlayer played an important role by helping the Al‐5%Ge flow into the bottoms of holes and vias. From the results of contact resistance measurements, contact holes with diameter <0.55 μm were filled with Al‐5%Ge, and the deviation of contact resistance and junction leakage current was small. As for conventional sputtering of Al‐Si, the contact resistance increased irregularly at the contact size of 0.8 μm because of poor step coverage.
Access this article
The computer you are using is not registered by an institution with a subscription to this article. Please choose one of the options below.
