Abstract
Proton exchange membrane fuel cells (PEMFCs) depend on platinum at the cathode to catalyze the oxygen reduction reaction (ORR) and maintain high performance. This report shows that the electrocatalytic activity of Pt is enhanced when it is dispersed in a matrix of hydrous iron phosphate (FePO). The Pt-FePO has 2 nm micropores with Pt dispersed as ions in
and
oxidation states. Increased ORR performance is demonstrated for the
(VC) materials compared to a standard 20 wt % Pt-VC catalyst on rotating disk electrodes with Pt-loadings of 0.1 mg(Pt) cm−2. The improvement in the ORR is attributed to the adsorption/storage of oxygen on the FePO, presumably as iron-hydroperoxides. The ORR activity of the Pt-FePO in air is close to that in oxygen at low current density, and therefore this catalyst has a distinctly unique behavior from Pt-VC. Contrary to Pt-VC, the Pt-FePO catalyst shows activity towards hydrogen and CO oxidation, but does not exhibit their characteristic adsorption peaks, suggesting that Pt ions in the iron phosphate structure are less sensitive to poisoning than metallic Pt. The results present opportunities for new low-Pt catalysts that extend beyond the current capabilities of Pt-VC. © 2004 The Electrochemical Society. All rights reserved.
Access this article
The computer you are using is not registered by an institution with a subscription to this article. Please choose one of the options below.

Although this pink powder is stable under fuel cell conditions, it is not feasible as a catalyst because it exhibits a low surface area and inferior ORR performance.
electrode contains approximately
VC and the standard is 20%
we assume that both materials are 50% porous, so the electrodes should be similar in thickness. Note that the thickness of the electrodes has an impact on the values measured and thinner electrodes may appear more active per unit Pt than thicker electrodes due to decreased diffusion resistance.