Atomic layer epitaxy (ALE) of Equation or symbol description not availableWO3 from Equation or symbol description not availableWF6 and Equation or symbol description not availableH2O has been studied. These precursors were found to yield very low deposition rates. This was attributed to a poor adsorption of Equation or symbol description not availableWF6 on the oxide surface. Attempts to increase the adsorption of the metal source by in situ generation of tungsten subfluorides were unsuccessful due to severe etching problems. Our results, however, showed that different Equation or symbol description not availableWOxFy compounds are good candidates for ALE of Equation or symbol description not availableWO3. The oxyfluorides were generated in situ by etching of tungsten oxide lumps with Equation or symbol description not availableWF6 at temperatures up to 600°C. No analysis of the generated Equation or symbol description not availableWOxFy precursors was carried out, but thermodynamic calculations suggest that the main etch products should be Equation or symbol description not availableWOF4 and Equation or symbol description not availableWO2F2. An ALE process based on the in situ generated oxyfluorides and Equation or symbol description not availableH2O as precursors was found to yield monoclinic Equation or symbol description not availableWO3 films at substrate temperatures as low as 200°C. The deposition rate at this temperature was about 0.8 Å/deposition cycle. The films deposited at 200°C contained small amounts (<2 atom %) of fluorine. © 1999 The Electrochemical Society. All rights reserved.