Abstract
The roughness of GaN surfaces produced by photoenhanced etching is significantly reduced by the introduction of an external bias voltage during the etching process. The root‐mean‐square surface roughness decreases from a maximum of approximately 1700 nm to a minimum of 20 nm as the bias voltage is increased from 0 to 2.5 V, and as the KOH concentration is decreased from 1.0 to 0.01 M. Etch rates as high as 0.4 μm/min are achieved at room temperature, producing surfaces with roughnesses of only 20 nm. © 1999 The Electrochemical Society. All rights reserved.
Access this article
The computer you are using is not registered by an institution with a subscription to this article. Please choose one of the options below.
