The galvanostatic plating of Cu-Al alloy was examined at a platinum electrode in solutions of Equation or symbol description not availableCu+ in the 60.0-40.0 mol % aluminum chloride-1-ethyl-3-methylimidazolium chloride room-temperature molten salt at 28°C using periodic-current plating techniques. The plating techniques that were investigated include pulse current, superimposed-pulse current, and reverse-pulse current. The composition of the electrodeposited alloy was determined by using rotating ring-disk anodic linear sweep voltammetry. The electrodeposition of Cu-Al is complicated by the instability of the alloy in solutions containing Equation or symbol description not availableCu+. If alloy electrodeposits are removed from cathodic protection while immersed in the plating bath, a condition that occurs during the pulse plating “off-time,” Equation or symbol description not availabletoff, Equation or symbol description not availableCu+ in the plating solution oxidizes Al from the electrodeposits. The rate of this displacement reaction is greatest for small values of Equation or symbol description not availabletoff but decreases as Equation or symbol description not availabletoff becomes longer, suggesting that a copper-rich layer forms on the electrodeposits that blocks the displacement reaction. The displacement reaction can be minimized by lowering the Equation or symbol description not availableCu+ concentration at the electrode surface through the application of a superimposed current during Equation or symbol description not availabletoff, whose magnitude is comparable to that of the limiting current for Equation or symbol description not availableCu+. © 2001 The Electrochemical Society. All rights reserved.