Dry etching of lead zirconate titanate (PZT) thin film and Pt/PZT stack structure was investigated using a Equation or symbol description not availableTiO2 hard mask in an inductively coupled plasma (ICP). An annealed Equation or symbol description not availableTiO2 thin film was employed as an etch mask for PZT and Pt/PZT stack etching. Etch characteristics of PZT thin films were examined with Equation or symbol description not availableCl2/O2/Ar etch chemistry in terms of the etch rate, the etch selectivity, and the etch profile. The etch selectivity of the PZT film to the Equation or symbol description not availableTiO2 mask was in the range of one to five at the etch conditions used in this study. It was found that the etch selectivity of the PZT film to the Equation or symbol description not availableTiO2 mask was strongly affected by the ratio of Equation or symbol description not availableO2 to Equation or symbol description not availableCl2 concentration. An X-ray photoelectron spectroscopy study revealed that the Equation or symbol description not availableO2 gas played an important role in obtaining high selectivity of Equation or symbol description not availablePZT/TiO2 films. Finally, the pattern transfer of Pt/PZT stack structure with the submicrometer dimension was achieved using a Equation or symbol description not availableTiO2 hard mask. The sidewall angle of etched Pt/PZT stack was approximately Equation or symbol description not available75° without etch redeposition or residue. © 2001 The Electrochemical Society. All rights reserved.