Abstract
This work reports the electrochemical fabrication of Mg–Ca alloys by co-deposition of Mg and Ca ions in KCl–CaCl2–MgCl2 melts at 943 K on tungsten electrodes. Cyclic voltammetry indicated that co-reduction of Mg(II) and Ca(II) ions occurs at about −2.23 V in KCl–CaCl2 eutectic melts at 943 K. The diffusion coefficient of Mg(II) in KCl–CaCl2 eutectic melts was determined by chronopotentiometry with Sand's equation. Open-circuit chronopotentiometry was applied to evaluate the equilibrium potential of Mg(II)/Mg(0) system. Bulk products of Mg–Ca alloys were obtained by galvanastatic electrolysis at 6.00 A cm−2 on tungsten electrodes. The compositions of obtained Mg–Ca alloys were analyzed by inductive coupled plasma atomic emission spectrometer (ICP-AES). X-ray diffraction (XRD) indicates that Mg–Ca alloys mainly comprise α-Mg and Mg2Ca phases. The microstructure and micro-zone chemical analysis of Mg–Ca alloys were characterized by scanning electron microscopy (SEM) with energy dispersive spectrometry (EDS) analysis.
Access this article
The computer you are using is not registered by an institution with a subscription to this article. Please choose one of the options below.
