Abstract
Gettering efficiencies of copper, whose bulk concentrations are lower than
in p-type silicon, have been evaluated quantitatively and the results are reported. Bulk copper introduced by intentional spiking and subsequent heat-treatment was shown to be gettered by bulk microdefects (BMDs), which had been introduced by heat-treatment prior to intentional contamination using a
isotope tracer as a probe. For evaluation of gettering efficiencies, we found the trace analysis of the
isotope to be critical and, thus, developed a procedure for trace analysis of bulk copper in the silicon bulk by modifying the published analytical technique, which allowed gettering efficiencies to be quantitatively evaluated for copper levels of below
. We also describe a few other parameters important to the evaluation of gettering efficiencies, including out-diffusion of copper through the silicon matrix, formation of BMDs, and low-temperature out-diffusion.
Access this article
The computer you are using is not registered by an institution with a subscription to this article. Please choose one of the options below.
