Abstract
The natural frequencies and associated mode shapes have been determined for the transverse vibration of three ID saw blades commonly used for crystal wafering. The purpose of the investigation was to determine what frequencies of excitation could excite blade natural frequencies, since excessive blade transverse motion can be a cause of severe crystal and blade damage. The fundamental frequencies for the 4 in.
in. OD, the 4 in. ID‐12 in. OD, and the 6 in.
in. OD blades, based on a maximum cutting edge hoop stress of 130,000 psi were found to be 780, 640, and 465 Hz, respectively. Experimental measurements have confirmed that cutting edge transverse motion exists with amplitudes up to 0.001 in. but at a frequency equal to the spinning speed, which is always an order of magnitude less than the computed natural frequency.
Access this article
The computer you are using is not registered by an institution with a subscription to this article. Please choose one of the options below.
