Abstract
High‐efficiency GaP green light‐emitting p‐n junctions have been reproducibly grown employing an overcompensation technique in a vertical dipping LPE system. In this technique both the n‐ and p‐type layers are grown in a single LPE crystal growth run, eliminating potential interface problems at the junction. For junction material grown at an initial temperature of 900° the EL quantum efficiencies of encapsulated mesa diodes ranged from 0.08 to 0.14% and averaged 0.10% at 5 mA (∼5–10 A/cm2). Minority carrier diffusion lengths (Le,Lh) and relative cathode°luminescence efficiency (CL) were measured in a scanning electron microscope. At excitation levels equivalent to current densities of ∼1–10 A/cm2 in a p-n junction, both Le and Lh range from 3 to 5with maximum measured values of
and
for material grown from 900° At the same excitation level the CL efficiency of the p‐layers was typically found to be approximately 2-3 times that of the ‐layers. Typical values for Le, Lh, CL, and the EL efficiencies were found to be larger by ∼50% for material grown from 900° compared to similarly grown material from 1000°C. The major assets of the overcompensation technique are the high degree of reproducibility in obtaining high efficiencies and that only a single growth process is necessary to form the p‐n junction.
Access this article
The computer you are using is not registered by an institution with a subscription to this article. Please choose one of the options below.
