The high-temperature stability of lanthanum silicate gate dielectric metal-insulator-semiconductor (MIS) devices with either Ta or Equation or symbol description not availableTaN electrodes has been studied. After a Equation or symbol description not available1000°C, Equation or symbol description not available10s rapid thermal annealing (RTA) treatment, devices with Ta gate metal undergo an equivalent oxide thickness (EOT) increase from 0.62 to Equation or symbol description not available1.57nm or higher, while devices with Equation or symbol description not availableTaN as the gate electrode experience an EOT increase from 0.62 to only Equation or symbol description not available1.12nm. An EOT less than Equation or symbol description not available1.0nm is achieved after a Equation or symbol description not available5s Equation or symbol description not available1000°C RTA, with a corresponding gate leakage of Equation or symbol description not available0.1A∕cm2. Medium-energy ion scattering and X-ray diffraction (XRD) analysis reveal that the Ta gate metal undergoes a phase change due to reaction with Equation or symbol description not availableN2 above Equation or symbol description not available800°C, while for Equation or symbol description not availableTaN no change in the XRD spectrum is detected. Interface state defect densities and leakage currents are reduced after the high-temperature processing. Results reveal the importance of the entire gate stack design and processing in obtaining good device properties.