To investigate whether unsaturated Equation or symbol description not availableNaCl vapor can have effects in hot corrosion, experiments have been conducted wherein specimens cut fromEquation or symbol description not availableCoCrAlY‐coated turbine blades were sprayed with Equation or symbol description not availableNa2SO4 (1–2 mg/cm2), and then exposed in a tube furnace at 1625°F under an air stream containingEquation or symbol description not available300 ppm NaCl (1/20 the Equation or symbol description not availableNaCl saturation pressure at 1625°F) with inspection and sulfate recoating every 24 hr. Several chloride effects were evident within 100–200 hr under this test regime. These included: (i) increasing the Equation or symbol description not availableNa2SO4vaporization rate; (ii) causing formation of a spalling Equation or symbol description not availableAl2O3 surface oxide; (iii) removing Cr by the formation of volatile complexes which apparently contain S and Na as well as Cr and Cl; (iv) interacting with Ti at the coatingblade interface; and (v) accelerating sulfidation‐oxidation attack upon theEquation or symbol description not availableCoCrAlY coating. This latter attack occurs when both blade metal and coating are exposed simultaneously to the sulfate, as at a cut edge. It is confined to the Equation or symbol description not availableCoCrAlY layer, and consists of a sulfidation front and oxidation front which traverse the coating successively, effectively stripping the coating from the supposedly less resistant blade alloy. Sodium chloride increases the kinetics of attack and appears to promote the formation of Equation or symbol description not available“Cr3S4” over Equation or symbol description not availableCrAlS as the predominate sulfide phase. A search for chloride was made by energy‐dispersive x‐ray analysis in the SEM, but despite the obvious Equation or symbol description not availableNaCl influences, no trace of chloride was found except possibly in the Ti interaction. The individualEquation or symbol description not availableNaCl effects are discussed in relation to earlier research results and as they may pertain to shipboard hot corrosion.