The electrochemical reactions of Equation or symbol description not availablePbTe in acetate buffer of pH 4.9 were compared with those in strongly acidic and alkaline solutions. Rotating ring‐disk studies provided information on the nature of soluble products, while the composition of the surface layers was analyzed by XPS. In the potential range of 0–0.4 VH a Te‐layer of only ∼3Å thickness is formed and an equivalent amount of Pb2+ is dissolved, this Te‐layer being too thin for coating or passivation purposes. At >0.4 VH an oxide layer is formed which contains mostly Equation or symbol description not availableTeO2 Equation or symbol description not available(H2TeO3) and ∼30% Equation or symbol description not availablePbO on the surface. There is a competing process between oxide film growth and dissolution of approximately 50% of these oxides. The reduction of Equation or symbol description not availableTeO2 and Equation or symbol description not availablePbO to elemental Te and Equation or symbol description not availablePbTe occurs at <0 VH and the reduction of Te to soluble tellurides at < −0.5 VH. By appropriate cyclic oxidation and reduction the Pb concentration in the anodic oxide and the reduced layer can be further decreased to ∼15%. The oxide layers are not good insulators (∼1000Å film, anodic current ≥10 mA/cm2 at 1.5 VH). The use of electrochemical processes on Equation or symbol description not availablePbTe for forming well passivating or insulating surface layers is limited.