Convection and segregation phenomena during vertical directional solidification of Ga‐doped Ge under stabilizing vertical thermal gradients were investigated. Microscopic growth rates were determined by interface demarcation, compositional profiles by single point spreading resistance measurements, and thermal characterization of the melt by direct thermal probing. It was found that destabilizing horizontal temperature gradients, even in melts with a diameter as small as 3 mm, led to convection with pronounced effects on solidification. Turbulent convection resulted in microscopic growth rate‐controlled dopant inhomogeneities similar to those observed for solidification under destabilizing vertical gradients. Under laminar convection dopant inhomogeneities were caused by perturbations in boundary layer thickness. Macrosegregation under both turbulent and laminar convection was controlled by the boundary layer thickness. A model based on diffusive and convective fluxes was developed describing laminar fluid flow and segregation; an experimental correlation between segregation and the Rayleigh number, consistent with the model, was obtained. Indirect evidence for diametrically antisymmetric fluid flow in the melt was obtained from lateral microsegregation across the interface. Theoretical and experimental results showed that complete elimination of convective interference is virtually impossible; however, “effective” diffusion‐controlled segregation was achieved at relatively high growth rates and low Rayleigh numbers.