Abstract
Galvanostatic transients arising from multi‐step processes of the type:
are treated mathematically for systems subjected to both activation and diffusion control. Analysis of error based on the error matrix is presented. The galvanostatic method is characterized by the information contents [
and
] for a single‐estimate analysis (i.e., estimate of
for known
or the reverse) and that for a two‐estimate analysis (simultaneous determination of
and
). The correlation between the estimates of
and
is given as a function of the dimensionless scale
. Information contents for
and
in single and two‐estimate systems are given and this permits the determination of the accuracy and the limits of the method as well as the choice of optimal experimental conditions. The optimal full time scale for estimation of
depends on the value of
. For
between 0.5–500,
varies from 6 to 18 (single‐estimate system) and from 4 to 25 (two‐estimate system). The upper limit for
in a single‐parameter estimation is 3–12 A cm−2 (for
) and the upper limit for
is 8 cm sec−1. This is three times greater than
for the coulostatic method. For a given value of
, the accuracy of the galvanostatic method is better than that of the coulostatic for systems when
, but is not as good when
. The upper limit of
and the accuracy of the galvanostatic method for two‐estimate analysis (
and
) are considerably lower than those for single‐estimate analysis. An iteration method is developed with which a large improvement is achieved. Estimation of
and
with a computerized curvilinear regression analysis is proposed.
Access this article
The computer you are using is not registered by an institution with a subscription to this article. Please choose one of the options below.
