Abstract
A high charging‐discharging efficiency was obtained for
battery, when a PPy film formed in
by electropolymerization was used in a
electrolyte after
anion undoping. The anion doping‐undoping process for the PPy film electrodes was examined with the usual electrochemical techniques. A
cell was also tested with a constant current charging‐discharging performance. The relationship between sweep rate and anodic peak current shown in the cyclic voltammograms obtained for the PPy film formed in the
electrolyte indicates a typical diffusion‐controlled process, while a reaction‐controlled process was found to be involved in the PPy film electrode formed in the
electrolyte. The relationship between undoping level and elapsed time indicated that the diffusion rate of the
doped in the PPy film formed in
has a higher value than that of the
doped in the PPy film formed in
. SEM observations showed that the PPy films formed in
were rougher than those formed in
. Infrared (IR) spectral measurements confirmed that there are no essential differences in the manner of bonding of the PPy films formed in
and
. Consequently, a morphology of the PPy films was suggested to be a very important factor in determining the kinetics of the anion doping‐undoping process and, therefore, charging‐discharging properties of
battery.
Access this article
The computer you are using is not registered by an institution with a subscription to this article. Please choose one of the options below.
