Abstract
Electrospinning has been known for its' ability in producing nanoporous fibres which uses electrical force to form a spinning jet out of a polymer solution. The electrospinning condition and polymer solution properties can influence the electrospinning jet formation as well as jet path. Polylactic acid (PLA) was dissolved in dimethylformamide (DMF) to produce a polymer solution. Bead is considered as a defect towards an electrospun fibres, yet previous study found that PLA/DMF produced beaded fibres for all concentrations. However, there is a limited study that explain the effect of concentration on the diameter of beads. Therefore, in this study we investigated the formation of electrospinning jet as well as the effect of PLA concentration of formation of beads, particularly the diameter of the beads. Polymer solution with different concentration was prepared. The concentration investigated in this study were 7.5, 10, 12.5, 15, 17.5, and 20 % w/v. Polymer solution was then subjected to the electrospinning process to evaluate the morphology of the electrospun produced via optical microscope. Simultaneously, the formation of electrospinning jet is observed with portable digital microscope. The morphology of the electrospun fibres, especially the fibre and bead diameter are analyzed using image analysis software, ImageJ. From this research, it is found that at voltage of 10 and 12.8 kV, a stable electrospinning jet can be formed which consists of 'Taylor cone', straight jet, and plume. Concentration from 7.5–20 % w/v were able to form electrospun fibres, yet only 12.5 and 15 % w/v PLA concentrations can produce an effective electrospun fibres with beads diameter of 3393 nm and 3642 nm, respectively. Also, the number of beads for both concentrations are 34 and 19, respectively. Since the main criteria in producing electrospun fibres is no beads or small and minimal beads at best, therefore 12.5 and 15 % w/v PLA concentration are considered as efficient electrospun fibres.
Export citation and abstract BibTeX RIS
Content from this work may be used under the terms of the Creative Commons Attribution 3.0 licence. Any further distribution of this work must maintain attribution to the author(s) and the title of the work, journal citation and DOI.