Paper The following article is Open access

Geology Structure Identification based on Polarimetric SAR (PolSAR) Data and Field Based Observation at Ciwidey Geothermal Field

, and

Published under licence by IOP Publishing Ltd
, , Citation R A Pradipta et al 2016 IOP Conf. Ser.: Earth Environ. Sci. 42 012008 DOI 10.1088/1755-1315/42/1/012008

1755-1315/42/1/012008

Abstract

Geological structure observation is difficult to be conducted at Quaternary volcanic field due to the classical problem at tropical region such as intensive erosion, dense vegetation covers, and rough terrain. The problem hampers the field observation especially for geological structures mapping. In order to overcome the problems, an active remote sensing technology based on Polarimetric Synthetic Aperture Radar (PolSAR) data was used in this study. The longer wavelength of microwave than optical region caused the SAR layer penetration higher than optics. The Ciwidey Geothermal Field, Indonesia was selected as study area because of the existence of surface manifestations with lack information about the control of geological structures to the geothermal system. Visual interpretation based on composite polarization modes was applied to identify geological structures at study area. The color composite Red-Green-Blue for HV-HH-VV polarizations provided highest texture and structural features among the other composite combination. The Linear Features Density (LFD) map was also used to interpret the fractures zones. The calculated LFD showed high anomaly about 3.6 km/km2 with two strike directions NW-SE and NE-SW. Interestingly, the surface geothermal manifestation agreed with the low anomaly of LFD. The geological structures consisted of ten faults were successfully detected and mapped. The faults type mainly are oblique-slip with strike directions NE-SW and NW-SE.

Export citation and abstract BibTeX RIS

Content from this work may be used under the terms of the Creative Commons Attribution 3.0 licence. Any further distribution of this work must maintain attribution to the author(s) and the title of the work, journal citation and DOI.

Please wait… references are loading.
10.1088/1755-1315/42/1/012008