Development of cutting force components in high-speed cutting on turning centre

The article deals with the investigation of high-speed cutting. The influence of cutting speed on the development of individual cutting force components in turning was determined. Cutting tests were carried out on turning centre during the machining of C45 medium carbon steel material. The cutting tool material was cubic boron nitride. Cutting speed was selected with respect to the high-speed cutting (HSC) based on previous studies. In the experiment, cutting force components were recorded. From the results, a decreasing trend in the cutting force values was observed from the cutting speed higher than 1100 m.min^-1. It can be caused by changing of metallurgical and mechanical properties in the cutting zone because the overall cutting resistance during HSC was reduced. Chips changed colour to orange during the machining due to temperature changes. No great benefit was observed when high-speed cutting for turning medium carbon steel material. The inefficiency, in this case, is caused by the high price and low tool life of the CBN cutting inserts as well as the cutting force that decreases slowly after the initial increase with a rapidly increasing cutting speed.