Investigation of the effects of main geometric parameters and flow characteristics on secondary flow losses in a turbine cascade

This paper presents numerical simulation results of a three-dimensional (3D) transitional flow in a stator cascade of an axial turbine. The influences of the main geometric parameters and flow characteristics including, the blade aspect ratio, pitch-to-chord ratio, inlet flow angle, and exit Mach number, on secondary flows development and end-wall losses, were studied. The numerical results were validated by the results of experiments conducted in the laboratory of the steam and gas turbine faculty of the Moscow Power Engineering Institute. The maximum difference between computed and experimental results was 2.4 %. The total energy losses decrease by 20 % when the exit Mach number changes from 0.38 to 0.8. Numerical results indicated that the blade aspect ratio had the most effect on secondary flow losses. The total energy losses increase by 46.6 % when the aspect ratio decreases from 1 to 0.25. The total loss of energy by 13.2 % decreases by increasing the inlet flow angle from 60 degrees to 90 degrees. Then by increasing the inlet flow angle from 90 to 110 degrees, the total loss rises by 3.6%. As the pitch-to-chord ratio increases from 0.7 to 0.75, the total energy losses are reduced by 12.2 %. Then by increasing the pitch-to-chord ratio from 0.75 to 0.8, the total energy losses increase by 6 %. As with experimental data, the numerical results showed that the optimal inlet flow angle and relative pitch for the cascade are 90 degrees and 0.75, respectively.