This site uses cookies. By continuing to use this site you agree to our use of cookies. To find out more, see our Privacy and Cookies policy.
Paper The following article is Open access

Intensity noise characteristics of intracavity contacted VCSELs with rhomboidal oxide current aperture for the magnetometric sensor with Cs133 vapor cell used in magnetoencephalography

, , , , , , , and

Published under licence by IOP Publishing Ltd
, , Citation M A Bobrov et al 2021 J. Phys.: Conf. Ser. 2103 012182 DOI 10.1088/1742-6596/2103/1/012182

1742-6596/2103/1/012182

Abstract

We demonstrate noise characterization of novel 894.4 nm vertical-cavity surface emitting lasers with intracavity contacts and a rhomboidal oxide current aperture (IC-VCSELs), dedicated to 133Cs D1 line compact optically pumped atomic magnetometers (OPM). The laser relative intensity noise, measured to be -139 dB/Hz at 10 kHz frequency in 1 Hz bandwidth for a laser optical power of 0.8 mW, is decreased with optical power growth. The IC-VCSELs polarization-resolved relative intensity noise is 143 dB/Hz at 10 kHz frequency in 1 Hz bandwidth for 0.8 mW. The emission linewidth of the VCSEL is about 55 MHz. The IC-VCSEL parameters are determined, such as emission linewidth ~ 50-60 MHz, optical power ~ 0.5-1.0 mW, at which the polarization-resolved RIN becomes close to the RIN, which makes it possible to use these lasers in various OPM Mz and Mx schemes. The ultimate sensitivity of OPM was estimated by the ratio of the magnetic resonance to the signal to noise level. It is shown that a OPM based on the IC-VCSELs, assuming magnetic resonance FWHM ~ 1 kHz, can achieve a shot noise-limited sensitivity around 20 fT in 1 Hz bandwidth without any polarization improvements by polarizer or polarization beam splitter cube (PBC). Developed IC-VCSELs is acceptable for use in compact OPM for magnetoencephalography.

Export citation and abstract BibTeX RIS

Content from this work may be used under the terms of the Creative Commons Attribution 3.0 licence. Any further distribution of this work must maintain attribution to the author(s) and the title of the work, journal citation and DOI.

Please wait… references are loading.
10.1088/1742-6596/2103/1/012182