Paper • The following article is Open access

Non-rigid shaft processing with pre-emphasis of tool trajectory on CNC machines

and

Published under licence by IOP Publishing Ltd
, , Citation A P Starostin and V F Pegashkin 2020 J. Phys.: Conf. Ser. 1515 022067 DOI 10.1088/1742-6596/1515/2/022067

Download Article PDF

Article metrics

60 Total downloads

Share this article

Author e-mails

andrey.starostin@urfu.ru

Author affiliations

1 Nizhny Tagil Institute of Technology (branch) Ural Federal University named after the first President of Russia B.N. Yeltsin, 59, Krasnogvardeiskaya st., Sverdlovsk Region, Nizhny Tagil, 622001, Russia

2 Ural Federal University named after the first President of Russia B.N. Yeltsin 19, Mira st., Yekaterinburg, 620002, Russia

Buy this article in print

Journal RSS
Sign up for new issue notifications
1742-6596/1515/2/022067

Abstract

This article presents shaft accuracy increase method using a mathematical modelling. This modelling considers deformation of process system at required process modes. Herewith, given are experimental findings for several approaches, which confirm the effectiveness of the method use. Thus, decrease of an error by at least 42% turned out well when using the given mathematical modelling.

Export citation and abstract BibTeX RIS

Previous article in issue
Next article in issue

Content from this work may be used under the terms of the Creative Commons Attribution 3.0 licence. Any further distribution of this work must maintain attribution to the author(s) and the title of the work, journal citation and DOI.

Please wait… references are loading.
10.1088/1742-6596/1515/2/022067