This site uses cookies. By continuing to use this site you agree to our use of cookies. To find out more, see our Privacy and Cookies policy. Close this notification
Skip to content

Study of particle pumping characteristics for different pumping geometries in JT-60U and DIII-D divertors

, , , , , , , , , , , , and

Published under licence by IOP Publishing Ltd
, , Citation H. Takenaga et al 2001 Nucl. Fusion 41 1777 DOI 10.1088/0029-5515/41/12/305

0029-5515/41/12/1777

Abstract

Particle pumping characteristics were compared between pumping from the inner side private flux region (IPP) and pumping from both sides of the private flux region (BPP) in the JT-60U W shaped divertor, and between JT-60U IPP and pumping in the DIII-D lower baffled divertor. The pumping flux for BPP is smaller than that for IPP by about a factor of 2 with weak in-out asymmetry of recycling neutral flux and by a factor of 3.5-6.5 with strong in-out asymmetry. The reduction of the pumping flux for BPP is consistent with Monte Carlo simulations, where backflow at the outer pumping slot is observed due to in-out recycling asymmetry. The pumping flux in DIII-D at Ip = 0.8 MA and BT = 1.6 T is comparable to or smaller than that for JT-60U IPP at Ip = 1.0 MA, BT = 3.8 T and Ip = 1.5 MA, BT = 3.5 T in the same density regime. In the DIII-D divertor with pumping from the private flux region, the pumping flux decreases with increasing in-out asymmetry. The pumping flux normalized by the integrated Dα emission over the whole plasma exhibits a similar dependence on the distance between the pumping slot and the strike point in JT-60U IPP and the DIII-D lower divertor with pumping through the outer divertor plasma region.

Export citation and abstract BibTeX RIS

10.1088/0029-5515/41/12/305