Erratum: Fabrication of highly conductive polyester fabrics using single-wall carbon nanotubes inks for EMI shielding [Jpn. J. Appl. Phys. 63 04SP01 (2024)]

Due to an error in the production process, there are several corrections needed in this article.

In the caption of Fig. 10, ΔR_S R_S should be ΔR_S. The correct caption and figure are shown below:

Zoom In Zoom Out Reset image size

On page 04SP01-5 the following sentence "Fig. 10 shows the ΔR_S R_S of the LT-SWCNT-polyester fabrics under 100 bending cycles. We observed about 1%–2% change in the ΔR_S R_S, which was considerably small." ΔR_S R_S should be corrected to ΔR_S to read "Fig. 10 shows the ΔR_S of the LT-SWCNT-polyester fabrics under 100 bending cycles. We observed about 1%–2% change in the ΔR_S, which was considerably small."

On page 04SP01-6 the following sentence "Furthermore, we simulated the SE using HFSS for ΔRSRS of 1%–2% (Fig. S6), in which the SE of the LT-SWCNT-polyester fabrics was estimated to be almost unchanged after the 100 bending cycles." ΔR_S R_S should be corrected to ΔR_S to read "Furthermore, we simulated the SE using HFSS for ΔR_S of 1%–2% (Fig. S6), in which the SE of the LT-SWCNT-polyester fabrics was estimated to be almost unchanged after the 100 bending cycles."