This site uses cookies. By continuing to use this site you agree to our use of cookies. To find out more, see our Privacy and Cookies policy.

Timepix3: a 65K channel hybrid pixel readout chip with simultaneous ToA/ToT and sparse readout

, , , , , , , , , , , , , and

Published 13 May 2014 © 2014 IOP Publishing Ltd and Sissa Medialab srl
, , Citation T Poikela et al 2014 JINST 9 C05013 DOI 10.1088/1748-0221/9/05/C05013

1748-0221/9/05/C05013

Abstract

The Timepix3, hybrid pixel detector (HPD) readout chip, a successor to the Timepix \cite{timepix2007} chip, can record time-of-arrival (ToA) and time-over-threshold (ToT) simultaneously in each pixel. ToA information is recorded in a 14-bit register at 40 MHz and can be refined by a further 4 bits with a nominal resolution of 1.5625 ns (640 MHz). ToT is recorded in a 10-bit overflow controlled counter at 40 MHz. Pixels can be programmed to record 14 bits of integral ToT and 10 bits of event counting, both at 40 MHz. The chip is designed in 130 nm CMOS and contains 256 × 256 pixel channels (55 × 55 μm2). The chip, which has more than 170 M transistors, has been conceived as a general-purpose readout chip for HPDs used in a wide range of applications. Common requirements of these applications are operation without a trigger signal, and sparse readout where only pixels containing event information are read out.

A new architecture has been designed for sparse readout and can achieve a throughput of up to 40 Mhits/s/cm2. The flexible architecture offers readout schemes ranging from serial (one link) readout (40 Mbps) to faster parallel (up to 8 links) readout of 5.12 Gbps. In the ToA/ToT operation mode, readout is simultaneous with data acquisition thus keeping pixels sensitive at all times. The pixel matrix is formed by super pixel (SP) structures of 2 × 4 pixels. This optimizes resources by sharing the pixel readout logic which transports data from SPs to End-of-Column (EoC) using a 2-phase handshake protocol.

To reduce power consumption in applications with a low duty cycle, an on-chip power pulsing scheme has been implemented. The logic switches bias currents of the analog front-ends in a sequential manner, and all front-ends can be switched in 800 ns. The digital design uses a mixture of commercial and custom standard cell libraries and was verified using Open Verification Methodology (OVM) and commercial timing analysis tools. The analog front-end and a voltage-controlled oscillator for 1.5625 ns timing resolution have been designed using full custom techniques.

Export citation and abstract BibTeX RIS

10.1088/1748-0221/9/05/C05013