H S Kim et al 2009 Supercond. Sci. Technol. 22 125016 doi:10.1088/0953-2048/22/12/125016
H S Kim, J B Song, N Y Kwon, K L Kim and H G Lee1
Show affiliationsThe superconducting properties of YBCO (yttrium barium copper oxide) coated conductors (CCs) are strongly dependent on their oxygen content. Degradation of the superconducting properties of a YBCO CC can occur due to a phase/structure transition caused by the oxygen diffusion out of the YBCO during heat-treatment or soldering, which is an inevitable process during the creation of a superconducting joint. Such variations in phase/structure are generally functions of temperature and oxygen partial pressure (PO2). Therefore, in order for a superconducting joint of YBCO CC to be feasible, it is important to examine the changes in the microstructure and oxygen diffusion behavior for YBCO CCs. This study examined the superconducting properties of YBCO CCs before and after a heat-treatment under a reduced PO2 followed by an oxygenation annealing process in an oxygen rich environment. Partial melting of YBCO without melting of the silver stabilizer layer was obtained for a sample heat treated for 60 s at 820 °C and
Torr. The superconducting properties of the sample heat treated at 820 °C were fully restored by an oxygenation annealing treatment for 15 h at 600 °C.
66.30.H- Self-diffusion and ionic conduction in nonmetals
Issue 12 (December 2009)
Received 12 July 2009, in final form 22 September 2009
Published 23 October 2009
H S Kim et al 2009 Supercond. Sci. Technol. 22 125016
N Itoh et al 2009 J. Phys.: Condens. Matter 21 474205
Jan H Meinke and Ulrich H E Hansmann 2007 J. Phys.: Condens. Matter 19 285215
C N Borca et al 2007 J. Phys.: Condens. Matter 19 315211
Rajesh Patel 2009 J. Opt. A: Pure Appl. Opt. 11 125004
B Cochain et al 2009 J. Phys.: Conf. Ser. 190 012182
Chih-Hao Chang et al 2009 Nanotechnology 20 495301
V I Arkhipenko et al 2009 Plasma Phys. Control. Fusion 51 125005
Alexei Kuzmin and Robert A Evarestov 2009 J. Phys.: Conf. Ser. 190 012024
J Cui et al 2009 J. Micromech. Microeng. 19 125015